Denver Service Center, National Park Service

This readme.txt provides information for installing and using
the NPS AutoCAD 2008 tools.  These files are intended for use with 
AutoCAD 2000, 2000i, 2002, 2004, 2005, 2006, 2007 and 2008 WHEN NOT ON THE Denver Service 
Center NETWORK.

These tools are not for use with AutoCAD release 13 or 14.  If you already
have the NPS R13/14 customization installed, you must install these NPS 
AutoCAD tools to a DIFFERENT location.
____________________________________________________________________________

Instruction for installing the NPS AutoCAD 2008 tools.

Contents: 
   NPS AutoCAD 2008 tools, including AutoLISP routines, template 
   drawings, standard symbols, standard details.
      
How to use: 

   Step 1. Download Npstools.exe by clicking on it's link from
      the page where you found this readme file.  Choose the "Save
      this program to disk" option, which will transfer Npstools.exe
      to your hard drive.

   Step 2. Install the files:
      To intall the NPS AutoCAD Tools, run the accompanying npstools.exe 
      file and follow the directions.  

      You can install these tools in any folder on a local or network
      drive. It is NOT recommended that you install the NPS Tools to 
      any folder underneath your AutoCAD installed folder.
   
   Step 3.  Configure AutoCAD:
      Follow the instructions that are presented at the end of the
      installation (step 2). 
      
   Once you successfully complete step 3, the NPS tools will automatically
   load each time you start AutoCAD.  

____________________________________________________________________________

If you have questions or problems, contact:

   Bruce Littlehorn
   National Park Service
   Denver Service Center
   email:  bruce_littlehorn@contractor.nps.gov